Introduction To RC Slope Soaring

Slope soaring is increasing in popularity for a number of reasons.

1. Slope soarers are silent so there are no noise objections which opens up many flying sites.

2. All you need is radio gear and a model. No fuel, engines or expensive starting equipment is required.

3. Any type of model aircraft can be flown from normal looking gliders to world war 2 fighter planes.

4. It offer something for every pilot. If you want to float about lazily you can. If you want to do high speed runs along the slope and perform aerobatics you can do that too.

Where Can I Fly ?

Wherever you can find a reasonable -sized hill with a 10-20 m.p.h. wind blowing straight into the slope, you can slope soar. The wind is deflected upward by the slope of the hill creating the lift which keeps the planes in the air

All hills have different characteristics and the amount of lift generated by a particular hill is regulated by the wind velocity and the amount of slope in the hill. Also a hill that has a smooth approach to it (free of trees, buildings and etc.) will almost always produce stronger lift. Don’t overlook places like dams, reservoirs, bluffs overlooking lakes and river valleys. They all make good flying sites. The ideal slope site is one in which there is a “bowl” created by either a curved hill or by a series of hills.

Flying Tips for Novice Soarers

Launch the Model into the wind out over the crest of the hill by throwing it with the wings level and nose pointed slightly down. Let the model build up speed and then make a turn that brings the flight path of the model parallel to the slope. When you need to turn the model around, make your turn into the wind away from the slope and again fly parallel to the slope. Repeat the above procedure when it is time to turn again. Flying this flattened figure eight coarse back and forth across the face of the slope is standard procedure. This helps keep the model in the maximum lift zone which yields the most altitude gain.

Landing

To land start with a fair amount of altitude, then fly the model slightly behind the crest of the slope, and try to fly a steady descending path right down to a landing on top of the hill. If you are too high on your landing approach, make S-turns to lose altitude or go around and try it again. Most slope soaring sites create an air turbulence on the back side of the hill. Avoid getting caught in this turbulence as it might cause you to lose control of your model and crash.

Balast

Depending on the model, when flying in winds of excess of 20 m.p.h. some balast may be needed. Stick-on lead weights are ideal for adding balast. Simply press them in place inside the fuselage directly over the C.G.

Aerobatics

Slope soarers don’t have engines to pull them through acrobatic maneuvers like power models do, so we have to rely on the lift and the speed of the model to perform aerobatics. Always pick up speed by diving the model before entering a maneuver. The amount of speed required, depends on the maneuver and the available lift. If you are new to slope soaring make your maneuvers into the wind at first until you feel comfortable.

It will take a little practice to master the art of slope soaring, but it is well worth the effort and can be very rewarding.


Sponsors